Drilling Engineering Design and Construction of Well Dong 11
Abstract
The planned depth of well Dong 11 is 5,780 m, many complicated conditions may exist in the drilling process of this well, such as loose cementation and high risk of hole collapse in the upper formation, leakage of Cretaceous strata, caving mudstone in Jurassic, possible high-pressured saltwater zone and hydrocarbon zone in Sangonghe formation. In addition, this block is located in fault ruptured zone. Based on the above problems, casing program design, BHA design, drill bit selection, drilling fluid design and the cementing design was optimized and the drilling engineering design and site construction of the well was introduced. No complicated condition occurred during the whole well construction. PDC bit was used in the upper well section and PDC bit combined with screw drilling technology was used in lower well section, the average rate of penetration is 4.77 m/h, compared with the offset wells, the drilling speed increased obviously and the good hole diameter validates the serviceability of a strong inhibitive heat-resisting plugging polymer anti-collapse drilling fluid system in this area.
Keywords
Full Text:
PDFReferences
[1] Tang, Z. J., & Shao, C. M. (2007). Drilling engineering design optimization and application. Petroleum Geology and Engineering, 21(3), 75-78.
[2] Tang, Z. J. (2005). Optimization method of casing program design. West-China Exploration Engineering, 17(5), 79-38.
[3] Guan, Z. C., Li, C. S., & Zhou, G. C. (2001). A method for designing casing program in deep and superdeep wells. Petroleum University Transaction, 21(6), 42-44.
[4] Ouyang, J., Liu, R. L., & Wang, Y. S. (2011). Drilling design and construction of well Huagu 1. West-China Exploration Engineering, (4), 76-77.
[5] Sun, J. S., Yang, Y. P., & An, S. M. (2009). Research on the theory and technology of drilling fluid for enhancing rate of penetration. Drilling Fluid & Completion Fluid, 26(2), 1-6.
[6] Javadpour, F. (2009). Nanopores and apparent permeability of gas flow in mudrocks (shales and siltstone). Journal of Canadian Petroleum Technology, 48(8), 15-20.
DOI: http://dx.doi.org/10.3968/9160
Refbacks
- There are currently no refbacks.
Copyright (c) 2016 Zhen WANG
This work is licensed under a Creative Commons Attribution 4.0 International License.
Reminder
We are currently accepting submissions via email only.
The registration and online submission functions have been disabled.
Please send your manuscripts to aped@cscanada.net,or aped@cscanada.org for consideration. We look forward to receiving your work.
We only use three mailboxes as follows to deal with issues about paper acceptance, payment and submission of electronic versions of our journals to databases:
caooc@hotmail.com; aped@cscanada.net; aped@cscanada.org
Articles published in Advances in Petroleum Exploration and Development are licensed under Creative Commons Attribution 4.0 (CC-BY).
ADVANCES IN PETROLEUM EXPLORATION AND DEVELOPMENT Editorial Office
Address:1055 Rue Lucien-L'Allier, Unit #772, Montreal, QC H3G 3C4, Canada.
Telephone: 1-514-558 6138
Website: Http://www.cscanada.net
Http://www.cscanada.org
E-mail:office@cscanada.net; office@cscanada.org
Copyright © 2010 Canadian Research & Development Centre of Sciences and Cultures